with Outsourced.9004 can you save RAM. Drop complete Folder in root. Files which
exist in Folder Outsourced remove it then alone from RAM.
With a File ttgo.bak, with your latest official Device-Navcore-Numbers, in root see
Home not more the wrong Version. Need you only if your Device has official NOT this
Version here.
You can create alone a ttgo.bak with correct Numbers or use inbuild auto Creation.
Use version.txt in root or /Config with your needed Numbers.
Current for:
TomTom GO, GO x00, GO x10, ONE 1st Edition, ONE 2nd Edition
A:7903
B:9183
Rider
A:7901
B:9181
some ONE 30-Series, XL 30-Series, ONE XL, ONE 3rd Edition
A:8010
B:9369
x20,x30,630
A:8351
B:9982
x40
A:8370
B:336164
With the Switchfiles in Root or in Folder Config can you configure alone your
Device.
Use the Files in root or /Config. Only root or Folder Config, NOT both!
you can also write the switchfile Names in a File setconfig.txt
to know how see into the Example File
Settings with a own unique Value needs a : on End
model:
changedtext:
sdid:
with setconfig.txt works the single switchfiles not more except
a seperate model.txt override the model: Entry in setconfig.txt
model.txt cycle.txt
version.txt works only separate
TTSoff = switch TTS off, not for Devices with original TTS
FMon = FMTransmitter on (for x10)
FMoff = switch auto enabled FM by some Emus again off, only for Device without
FM, Mp3-Player not more available
btoff = disable BT, if you not need, save then a little more RAM
bton = if you not have BT enable it Button for Speedcams in Menu
noqfixdel = disable Quickfix erase after you have press reset, if you wonder where
is gone qfixfiles normally, not for Sirf
delgns = remove (Start,supend) old TMC-Data (gns/gnsdata)
delmap = delete each boot currentmap.dat
cleanflash= delete all from Flash what is possible (*.mac etc.), Settings lost
runcheck = check a few "important" Files, view config.txt for Result
changedtext: = you can change the Text on Status/Info Screen, write your own Text
in the File
SDid: = write for each SD/Memory a other Number inside and you can for each use a
own different Mainsetting
usesetting= use always Settings from SD, not the in Device itself saved Settings
model: =see down
model.txt = write one from following inside
ori = switch to your real Device
x20 = switch to x20 Emulation
x30 = switch to x30 Emulation
x40 = switch to x40 Emulation
x40light(2,3) = similar to x40 Emu. no Voice Input and BT Stuff
ttssdk
xls
x50 is Standard
cycle.txt = switch each reset between Setting from cycle.txt <> model.txt
It Backup also the Mainsettings between both Emus.
