AW: Qbox lädt nicht
also, bin wieder da,
updet mit RS232 ok
dann aber das hier:
U-Boot 1.2.1 (Sep 10 2008 - 17:58:26)
CPU: IBM PowerPC STBx25xx(51510950) at 252 MHz (PLB=63)
16 kB I-Cache 8 kB D-Cache
Board: QBOX ONE
I2C: ready
DRAM: 64 MB
FLASH: 512 kB
NAND: NanD_Command (ReadID) got ec 56
Flash chip found:
Manufacturer ID: 0xEC, Chip ID: 0x56 (Samsung K9F1216U0A)
1 flash chips found. Total nand_chip size: 64 MB
NAND read: device 0 offset 62914560, size 524288 ...
524288 bytes read: OK
Programming Xilinx Spartan 3 ..
Program Complete.
devices_init
i2c_init
drv_video_init
I2c read: failed 4
failed.
checking welcome image... ok.
clear screen.
drv_system_initdrv_nc_initjumptable
console
Net: DM9000#0
Warning: DM9000#0 MAC addresses don't match:
Address in SROM is 7F:C8:02:A6:90:01
Address in environment is 00:19:28:F1:A2:C9
IDE: IDE detected on IOADDR: f2000000
ide reset not yet implemented
ide reset not yet implemented
Bus 0: not available
NAND read: device 0 offset 62783488, size 131072 ...
131072 bytes read: OK
NAND read: device 0 offset 62783488, size 131072 ...
131072 bytes read: OK
I2c read: failed 4
failed.
Rear Button Released
Hit any key to stop broadcast: 2 0
Broadcast message aborted.
Hit any key to stop autoboot: 2 0
[u-boot@duodvb boot]$
[u-boot@duodvb boot]$
[u-boot@duodvb boot]$ version
U-Boot 1.2.1 (Sep 10 2008 - 17:58:26)
[u-boot@duodvb boot]$ nand info
Device 0: Samsung K9F1216U0A at 0xffd00000 (64 MB, 16 kB sector)
[u-boot@duodvb boot]$ nand bad
Device 0 bad blocks:
[u-boot@duodvb boot]$ run fpga
NAND read: device 0 offset 62914560, size 524288 ...
524288 bytes read: OK
[u-boot@duodvb boot]$ loady $upgrade_buffer
## Ready for binary (ymodem) download to 0x037F0000 at 115200 bps...
CCCC---------------------------------------------------------------
-----------------------------------------------------------------------
und es bleibt stehen
wird mir wohl nicht anderes bleiben als abzubrechen
und nochmal versuchen, diesmal mit orginal soft
nachtrag:
versuch mit orginal soft,
oberer balken bei Q updater mit " TOTAL " bleibt leer,
unterer balken " Partial " sendet daten
und was bedeuten diese striche am ende
ist das upload dan fertig