ok, klasse, danke werde es probieren.. Vielen Vielen Dank für die schnelle Hilfe. Werde berichten...
Wieso wurde mir Neutrino angeboten als Update? Naja jetzt ist es passiert...
UPDATE: Probiere es gerade mit einem frisch gekauften USB Seriell Adapter zumindes bekomme ich schon mal ne Verbindung darüber und sehen was da so auf der Box abgeht .-)
Nun diser Fehler:
Board: STb7100-mboard
U-Boot 1.1.2 (STLINUX_2_0p1) (Feb 23 2008 - 17:07:31)
DRAM: 32 MB
write time out = 1, clock = 40
write time out = 1, clock = 40
Flash: 16 MB
In: serial
Out: serial
Err: serial
pll0 freq 531
pll1 freq 399
Net: VFD_Driver Init
VFD_Controller Type : NEW Kathrein VFD
board_version = 0
Button_value = 7
Hit any key to stop autoboot: 0
STB7100-REF> saveenv;loadb a4000000;bootm a4000000
Saving Environment to Flash...
env buffer crc = c985b077, data = 85e0000c
..
Un-Protected 2 sectors
Erasing Flash...
.. done
Erased 2 sectors
Writing to Flash... .done
..
Protected 2 sectors
## Ready for binary (kermit) download to 0xA4000000 at 115200 bps...
## Total Size = 0x0000f4bc = 62652 Bytes
## Start Addr = 0xA4000000
## Booting image at a4000000 ...
Image Name: UltimateFlashRecovery by SoLaLa
Image Type: SuperH Linux Standalone Program (gzip compressed)
Data Size: 62588 Bytes = 61.1 kB
Load Address: 85401000
Entry Point: 85401000
Verifying Checksum ... OK
Uncompressing Standalone Application ... OK
16 MB
In: serial
Out: serial
Err: serial
VFD_Driver Init
(Re)start USB...
USB: scanning bus for devices... 3 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading /kathrein/ufs910/ufr910.img
** Unable to read "/kathrein/ufs910/ufr910.img" from usb 0:1 **
USB fatload not available... trying ext2...(Re)start USB...
USB: scanning bus for devices... 3 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
Failed to mount ext2 filesystem...
** Bad ext2 partition or disk - usb 0:1 **
ready, checking and resetting now
CRC32 for a4040000 ... a4ffffff ==> 0cd6fe99
UPDATE:
Ist das der USB Bug dabei habe ich einen alten 128MB Flash USB Stick .. ich teste es nun mit einem 4GB Stick... update folgt ...
So ich bin jetzt am Ende ich habe 3 Stciks ausprobiert, das rennt so schnell durch ich bekomme nicht mal die Loggs nach dem ich die UFS.exe übertragen habe bootet das Teil wieder direkt in Neutrino AAF :-( Das schlimme ist dieses Image funktioniert kaum also ich bekomme da nur die hälfte der Sender selbst nach manuellem Scan und das auch nur manchmal ...
Kann mir einer einen USB Stcik nennen den ich erwerbe damit ich das wieder hin bekomme :-(
oh man WE ohn TV ...