Workaround for Linux DeltaFlashLoader Problem

[Bleeding]

Under certain circumstances, the DeltaFlashLoader under Linux will not start programming the CAM, because the Bootloader is missed after powering. To fix this timing issue, one has to set the low latency mode for the serial port. To do so, the setserial command is required:

# apt-get install setserial

Then, one has to set the low latency mode on the respective serial port of the programmer (e.g. /dev/ttyUSB0):

$ setserial /dev/ttyUSB0 low_latency

Now the DeltaFlashLoader should not get stuck at "Waiting cam connection..." after powering the PCMCIA board any longer:

# ./deltaFlashLoader /dev/ttyUSB0 -firmware cobra_01.30.bin 
Waiting cam connection...

Flashing...
100% [=========================================================================]
Flashing successfully completed

Keep in mind that the DeltaFlashLoader has to be run with root rights.

We will prepare a version of the DeltaFlashLoader for Linux that will set the low latency mode by itself. So this workaround will just be required temporarily...

 

[Nappy08]

AW: Workaround for Linux DeltaFlashLoader Problem

Thread von oben gelöst. Mit Loader ab Version 1.37 nicht mehr nötig. Der aktuelle Loader ist hier in der Linksammling zu finden. Link