jdauto73300
Newbie
- Registriert
- 22. September 2024
- Beiträge
- 1
- Reaktionspunkte
- 0
- Punkte
- 1
- Marke / Hersteller
- Audi
- Modell
- A4 B8
- Interne Modellbezeichnung
- 2.0TDI CR
- Erstzulassung (MM/JJJJ) zB: 06/2015
- 11/2008
Hello I find myself with a problem on an Audi A4 ECU from 2008
The vehicle is stuck in the workshop and the customer puts a little pressure on me
I didn't know the reading system of this Bosch edc17cp14 ECU and I only backed up the Eeprom and the Mirco but not the full backup with the flash.
So I tried to put a full backup bought on the internet, but the calculator no longer has credentials and is not recognized by the car, I tried to make a full backup but it saves me a file that is not accepted at the ktag in boot mode to unlock the write tprot protocol.
The writing under Kess goes well, the reading under ktag too but nothing works every time it tells me to send my file for recognition to the supplier and I have nothing official to do it
In addition my full backup bought on the internet and a 4096KB file, which I reduced to 2048KB by Winols so that it can be used to write, now I don't know what to do anymore I'm lost
Bosch EDC17CP14 ECU
SW: 069636
HW: H01
Case : 03L906022JM 9979
EVECM20TDI
problem solved by flashing with an original file without checking the kess sound file selection box, this reset the calculator identifiers
The vehicle is stuck in the workshop and the customer puts a little pressure on me
I didn't know the reading system of this Bosch edc17cp14 ECU and I only backed up the Eeprom and the Mirco but not the full backup with the flash.
So I tried to put a full backup bought on the internet, but the calculator no longer has credentials and is not recognized by the car, I tried to make a full backup but it saves me a file that is not accepted at the ktag in boot mode to unlock the write tprot protocol.
The writing under Kess goes well, the reading under ktag too but nothing works every time it tells me to send my file for recognition to the supplier and I have nothing official to do it
In addition my full backup bought on the internet and a 4096KB file, which I reduced to 2048KB by Winols so that it can be used to write, now I don't know what to do anymore I'm lost
Bosch EDC17CP14 ECU
SW: 069636
HW: H01
Case : 03L906022JM 9979
EVECM20TDI
Du musst Regestriert sein, um das angehängte Bild zusehen.
problem solved by flashing with an original file without checking the kess sound file selection box, this reset the calculator identifiers
