Mpcs erkennt kein Smargo

Hallo , hat jemand schon mal mpcs über ein Smargo laufen lassen??
Bei mir kommt folgende Ausgabe:
Rechner Debian

signal handling initialized (type=sysv)
2010/01/06 20:14:51 [ s ] monitor: initialized (fd=6, port=1000)
2010/01/06 20:14:51 [ s ] camd 3.3x: disabled
2010/01/06 20:14:51 [ s ] camd 3.5x: disabled
2010/01/06 20:14:51 [ s ] cs378x: disabled
2010/01/06 20:14:51 [ s ] newcamd: initialized (fd=7, port=14000, crypted)
2010/01/06 20:14:51 [ s ] CAID: 1702
2010/01/06 20:14:51 [ s ] provid #0: FFFFFF
2010/01/06 20:14:51 [ s ] newcamd: initialized (fd=8, port=11000, crypted)
2010/01/06 20:14:51 [ s ] CAID: 1833
2010/01/06 20:14:51 [ s ] provid #0: 000000
2010/01/06 20:14:51 [ s ] radegast: disabled
2010/01/06 20:14:51 [ s ] pandora: disabled
2010/01/06 20:14:51 [ s ] resolver thread started
2010/01/06 20:14:51 [ s ] logger started (pid=11048)
2010/01/06 20:14:51 [ s ] resolver started (pid=11049, delay=30 sec)
2010/01/06 20:14:51 [ s ] reader started (pid=11050, device=/dev/ttyUSB1, detect=cts, speed=14400)
2010/01/06 20:14:52 [ r 0002 ] Open /dev/ttyUSB1
2010/01/06 20:14:52 [ r 0002 ] Device: /dev/ttyUSB1, 14405 bps; 8 bits/byte; Even parity; 2 stopbits; dtr=1; rts=0
2010/01/06 20:14:54 [ r 0002 ] card detected
2010/01/06 20:14:56 [ r 0002 ] Device: /dev/ttyUSB1, 14405 bps; 8 bits/byte; None parity; 2 stopbits; dtr=1; rts=0
2010/01/06 20:14:57 [ r 0002 ] Protocol: T=14: WWT=333 WI=10 F=625 Clock=9.00Mhz
2010/01/06 20:14:57 [ r 0002 ] ATR: 0000000000000000000000000000000000000000000
2010/01/06 20:14:58 [ r 0002 ] type: irdeto, caid: 1702, acs: 3.84
2010/01/06 20:14:58 [ r 0002 ] ascii serial: xxxxxxxxxx, hex serial: xxxxxxx, hex base: 1A
2010/01/06 20:15:01 [ r 0002 ] card system not supported
2010/01/06 20:15:01 [ r 0002 ] card initializing error


Habe auch schon andere S02 , andere Baudrate versucht!!

gruß doc.error