Schau dir bitte mal den kompletten Log auf der seriellen Konsole im IPL Modus an wenn Emergency startet. Slay -9 funktioniert nicht auf einer MHI2 Unit, aber die Unit sagt dir was sie möchte, bevor sie den Countdown startet.
Wenn du dort schreiben kannst, schreibe folgendes Kommando rein
echo dummy > /HBpersistence/DeveloperMode
Wenn die Datei im Laufwerk vorhanden ist, wird der Countdown beim nächsten Start deaktiviert.
Wenn du fertig bist mit dem recovern, lösche die DeveloperMode Datei dort wieder aus dem Verzeichnis.
Wenn du es in der gegebenen Zeit nicht schaffst, die Kommandos einzugeben, benutze Notepad und gebe die Kommandos dort ein und arbeite mit Copy&Paste.
Das MMX kannst du dort nicht flashen, da eine SD Karte nicht mehr erkannt wird. Wie du das MMX reparierst, findest du im Mibwiki.
—-
Check the Full Log in IPL while Emergency is starting. Slay -9 does not work on MHI2 Unit but it tells you, what you have to do, before starting the Countdown
So make when it is possible the command
echo dummy > /HBpersistence/DeveloperMode
so when the file is inside the directory, the Countdown will be removed on next start.
After Finishing the recovery of the Unit, remove the Developer Mode file again from the directory.
When you have Problems to get the Commands into the Unit, than use notepad, Write the Commands into it and make Copy&Paste
The MMX can not be flashed from this mode, because a SD Card will not be seen with a broken mmx. You can find Information on Mibwiki site, how to repair it.