bevor die Fragen kommen, hier ist ein How to vom support forum
Guide How To FLASH NEW FIRMWARE on Cloud-Ibox2+PLUS receivers
SOFTWARE UPGRADING STEPS:
1.Download the software, unzip it untill you see the expeedlx folder
2.Copy the expeedlx folder to one USB
3.Plug the USB to the Cloud ibox2 plus or Cloud ibox3
4.Power on
5.The receiver will read the USB folder expeedlx and update
6.Wait untill you see the front panel DONE.
7.Power off, take out the USB
8.Restart.
NOTE: It does not state if it matters which USB port is used so try them both if you have problems with either front or back!!
Habe aber noch eine Frage zum VTI Image........
hat schon einmal einer ein VTI Image versucht ??? Ich finde das VTI Image am besten und würde es gerne weiter benutzen.........
Es gibt jetzt eine bessere Anleitung zum flashen von cloud ibox2 plus und cloud ibox 3. Werde ich heute hier reinkopieren. habe gelesen, dass paar Leute mit der ersten Anleitung keinen Erfolgen hatten.
@hotwebnet
für cloud ibox 2 plus und cloud ibox 3 gibts kein Vti Image :emoticon-0138-think
Hallo,
hab heute ein iBox Cloud II Plus bekommen, mit vorinstalliertem OpenPLI 4.0 Image.
Nun wollte ich das OpenAT einspielen, leider ohne Erfolg, nach dem Einschalten kommt im Display Up und der USB Stick blinkt ein wenig hin und her.
Dann startet nach ein paar Sekunden das OpenPLI wie gehabt.
die cloud ibox 2 plus soll ja ein clone der xpeed lx1 sein. für die originalbox gibts ein bootloader update, das die taktfrequenz von 500 auf 750 mhz hochsetzt. hat das schon mal einer mit der clone box probiert? Link ist nicht mehr aktiv.