Die Anweisungen sind diese
ifconfig ra0 unten, ra0 ifconfig hw ether XX: XX: XX: XX: XX: XX ifconfig ra0 up; add route default gw 192.168.1.1
Aber mit der ersten Anweisung, die Verbindung verloren gegangen ist, und der Rest weiß nicht, ob sie laufen, weil nach einer langen Zeit Matrix bleibt wie tot, und Menüs von ihm, nicht dem WiFi-Netzwerk verbinden (es ist unmöglich Scan-Netze), WLAN-Modul ist offline ...
I think you have to unplug your MCA from the device and plug it in after a Minute. Your router identifies the MCA by its MAC-Address and its not sure, if MCA broadcasts the "new" MAC immediately.
Try to put the commands in a script and name it e.g. "cmac.sh". Copy it to the MCA and execute it. The MCA will execute all commands even when the Telnet-session interrupts.
Good lick
Hola barsum y bienvenido al DEB,
no entiende por que te importa campiar el MAC, que normalmente el MAC solo es visible dentro tu RED.
El metodo que tu ha descrito debe estar bien.
Puedes probar a crear un script en /etc/init.d/ y activarlo en /etc/rc.d/rc.conf
saludos
dirtyharry123
___________________________
Hello and welcome to DEB Barsum,
means no matter you change the MAC, the MAC normally only visible inside your RED.
The method you described should be fine.
You can try to create a script in / etc / init.d / and activate it in / etc / rc.d / rc.conf
regards
dirtyharry123
Wir verwenden Cookies und ähnliche Technologien für folgende Zwecke:
Akzeptieren Sie Cookies und diese Technologien?
Wir verwenden Cookies und ähnliche Technologien für folgende Zwecke:
Akzeptieren Sie Cookies und diese Technologien?