Support Nun muss FDA bald wieder rann an freetz-ng

./push_firmware 2700_08.06.all_freetz-ng-26903M-aab624c2a6.image -prg ftp -map 0x10000000

 * Analyzing '2700_08.06.all_freetz-ng-26903M-aab624c2a6.image.image' ...
 * Product: Fritz_Box_HW301 (FRITZ!Repeater 2700)
 * Using dos2unix binary: /usr/bin/dos2unix
 * Using tar binary: /usr/bin/tar
 * Using ftp binary: /usr/bin/tnftp
 * Target host: 192.168.178.1
 * Outgoing IP: 192.168.178.12
 * Flash mode: fit-boot
 * Allowed memory size: <detect>
 * Designated linux_fs_start: <other>

 !!! WARNING !!! WARNING !!! WARNING !!! WARNING !!! WARNING !!!
 !!!  THERE IS NO WARRANTY AT ALL !!! USE AT YOUR OWN RISK   !!!

 * Are you sure, that you want to flash this file to the device?
   2700_08.06.all_freetz-ng-26903M-aab624c2a6.image
   Proceed? (y/[n]) y

 * You should now reboot your box (192.168.178.1). Waiting for shut down.
   Switch off, if reboot is not detected because it happens too quickly.
   Some newer bootloader versions allow to flash on power-cycle only.
   .........
 * No reply from box, assuming switch-off or restart. Trying to re-detect box.
   Waiting ......ping: connect: Das Netzwerk ist nicht erreichbar
.ping: connect: Das Netzwerk ist nicht erreichbar
.ping: connect: Das Netzwerk ist nicht erreichbar
.ping: connect: Das Netzwerk ist nicht erreichbar
.ping: connect: Das Netzwerk ist nicht erreichbar
.ping: connect: Das Netzwerk ist nicht erreichbar
... found!

 * Reading 'env' file to /tmp/freetz_env_0Td
Timeout!!!!!!!!!!!!!!!!!!
   ProductID:     
   HWRevision:     
   HWSubRevision:     
   memsize:     
   linux_fs_start:     

You are not connected to the bootloader of the device.

STEP 1: UNPACK
source firmware file: dl/fw/FRITZ.Repeater_2700-08.xx-12xxxx-Inhaus.image
checking signature: valid
unpacking firmware image
unpacking fitimg file
TYPE unknown: avm,urlader
ERROR: unpacking failed
make[1]: *** [Makefile:423: firmware-nocompile] Error 1
[\spoiler]