Hallo,zusammen
Hat schon jemand Erfahrungen mit der NCam 1.4 gemacht bzw. weiss jemand wie man sie korrekt ans laufen bekommt auf einer Vu+Duo+OpenATV Image ?
Moin, versteh ich nicht so ganz was genau müsste ich als erstes tun ?
Ich habe die enigma2-plugin-softcams-ncam-openatv_V1.4_all.ipk auf meiner VU+ Duo installiert damit sollte Csat France wieder laufen tut es auch nur halt eben nicht alle Sender
Woran kann das liegen ???
device = host,port
user = user
password = password
group = 1
cccversion = 2.0.11
disablecrccws_only_for = 0500:032830
cccmaxhops = 2
ccckeepalive = 1
audisabled = 1
[gbx]
fix for local card change (card detected/ ejected) not reported to peers
Change two defaults to more reasonable values
-Webif
-Correct cooldown parameter in webif
-Improve the Webif configuration screen.
-Add httpreadonly as a parameter in the webif
-Make all config parameters for the webif clickable to point to the Wiki
-Small reorganization of the parameters that display additional infos in the Status screen to place then in the same order as they are displayed when we enable them.
[gbx]
add feature
block ecm from specific peer(s)
ignore specific peer(s) entirely
fix Warning ref. cs_readlock timeout
code clean up and cosmetics
[DOC]
add optional parameter to Ncam.conf [g
Hab das jetzt mal getestet mit der OScam 11293 leider mit dem gleichen Ergebnis es werden nur ein paar Sender hell genau die selben die auch mit der NCam 1.4 hell werden