AW: Gbox 2.25 läuft nicht mit UM I02 karte
Hi
Es gibt da in der gbox.config eine Zeile, so in etwa:
# demux, multicam/comport configuration
# *x ** ; x = device nummber to be used (0= default)
# D* ** ; force use of /proc/bus/gtx for cw write operations
(in the dbox2 the gbox writes directly the CW's, 00 is the
recommended mode ! No drivers are required) use D* ** ONLY if
you have Problems. 0* ** should be prefered !!!
# F* ** ; write CW's in both devices (used for PVR in STB04xxx devices)
# ** y* ; y=0001b (0x1*) use slot1 as Multicam (only on STB04xxx)
# ** y* ; y=0010b (0x2*) use slot2 as Multicam (only on STB04xxx)
# ** y* ; y=0011b (0x3*) use slot1 and slot2 as Multicams (only on STB04xxx)
# ** *z ; z=0001b (0x*1) use com1 as Multicam
# ** *z ; z=0010b (0x*2) use com2 as Multicam
# ** *z ; z=0011b (0x*3) use com1 and com2 as Multicams
# ** yz ; yz=00110011b (0x33) use slot1+slot2+com1+com2 as Multicams
# ** *z ; z=0100b (0x*4) invert CTS detection on com1
# ** *z ; z=1000b (0x*
Du musst angemeldet sein, um Bilder zu sehen.
invert CTS detection on com2
# example: yz = 0x0A = 00001010 (use com2 with inverted CTS detection line)
V: { F0 10 }
DIESE HIER
Die V:-Line ist dafür verantwortlich. Gucke mal was bei dir drin steht und schreibe es hier rein.
gruss