Zeig mal dein Log was schief läuft. Zum neu Anfang müßte ein kompletter Recovery eingespielt werden was etwas kompliziert ist.
root@MyCloud:/# apt-get install openmediavault
Reading package lists... Done
Building dependency tree
Reading state information... Done
The following NEW packages will be installed:
openmediavault
0 upgraded, 1 newly installed, 0 to remove and 0 not upgraded.
1 not fully installed or removed.
Need to get 0 B/780 kB of archives.
After this operation, 5469 kB of additional disk space will be used.
perl: warning: Setting locale failed.
perl: warning: Please check that your locale settings:
LANGUAGE = (unset),
LC_ALL = (unset),
LANG = "ru_RU.UTF-8"
are supported and installed on your system.
perl: warning: Falling back to the standard locale ("C").
locale: Cannot set LC_CTYPE to default locale: No such file or directory
locale: Cannot set LC_MESSAGES to default locale: No such file or directory
locale: Cannot set LC_ALL to default locale: No such file or directory
Selecting previously unselected package openmediavault.
(Reading database ... 45851 files and directories currently installed.)
Unpacking openmediavault (from .../openmediavault_1.19_all.deb) ...
Setting up collectd (5.1.0-3+deb7u1) ...
[....] Restarting statistics collection and monitoring daemon: collectd not restarting, configuratio[FAILor failed!
invoke-rc.d: initscript collectd, action "restart" failed.
dpkg: error processing collectd (--configure):
subprocess installed post-installation script returned error exit status 1
dpkg: dependency problems prevent configuration of openmediavault:
openmediavault depends on collectd (>= 5.1.0); however:
Package collectd is not configured yet.
dpkg: error processing openmediavault (--configure):
dependency problems - leaving unconfigured
Errors were encountered while processing:
collectd
Könntest du mir die Möglichkeit aufzeigen, wie man ein komplettes Recovery einspielt ?
Würde mich interessieren, wenn es dir nicht zu viel Mühe macht
Was mir noch aufgefallen ist, ich finde nur eine Partition, die auf welcher das Wheezy installiert ist.
Fehler war vermutlich bei der Installation, dass der 2 Part run_me_after_reboot.sh nicht ausgeführt wurde.
Ich habe es dann nochmals manuell ausgeführt, hat aber leider nichts gebracht.