matrix cam air external power?

[xax2]

How change the cam to put external power?

Du musst dich Anmelden oder Registrieren um diesen link zusehen!

 

[geiselmen]

AW: matrix cam air external power?

https://www.digital-eliteboard.com/...trix-Cam-Air&p=1502405&viewfull=1#post1502405

 

[xax2]

AW: matrix cam air external power?

thanks geiselmen.
I'm not sure if I have to cut a track. I have to cover the connection with the pcmcia?
Link ist nicht mehr aktiv.

 

[geiselmen]

AW: matrix cam air external power?

Yes it´s Ok

 

[xax2]

AW: matrix cam air external power?

I can cut the track or I can block the contact, right?

 

[geiselmen]

AW: matrix cam air external power?

Yes its ok when you Block the contact or you Cut the rack

 

[emilc]

AW: matrix cam air external power?

Hi i have a question regarding externale power for the mca wifi, when i look at the different pics on the forum, it says that i have to "Leiterzug auftrennen"remove the little cap, but on my card i dont have any Leiterzug as showing on the pic.

 

[geiselmen]

AW: matrix cam air external power?

Make this Link ist nicht mehr aktiv. than its ok.

 

[emilc]

AW: matrix cam air external power?

Hi geiselmen,
i just did the mod, but i have a problem. i keep loosing the wifi connection, plus when i try up upload a new firmware via filezilla server, my max download speed is 6kb and then after few min. it times out.
the power supply that i used is 5v 3mA

 

[geiselmen]

AW: matrix cam air external power?

i havent a answer. i think the wifi signal is to bad.

 

[emilc]

AW: matrix cam air external power?

Thanks anyway.. The router is few meters away. And when making a search it says 70-80% signal and some times 30-50%. I will unsoiled the power supply just to test if it has something to do with it. I will return back when I have tested it

 

[przemoka]

AW: matrix cam air external power?

Du musst dich Anmelden oder Registrieren um den Inhalt der Angebote zu sehen!

Are you sure your power supply is OK? 3mA is a very weak amperage and I think you need a stronger power supply. I think the 5V 500mA would be sufficient enough to run it without problems.